Development

Examples:

Sensors / Smart Water Xtreme

» Sw xtr 06: OPTOD sensor reading

Last edition: Nov 13th, 2018 |

Basic example that turns on, reads and turn off the sensor. Measured parameters are stored in the corresponding class variables and printed by the serial monitor.

» Sw xtr 10: PHEHT sensor reading

Last edition: Nov 13th, 2018 |

Basic example that turns on, reads and turn off the sensor. Measured parameters are stored in the corresponding class variables and printed by the serial monitor.

» Sw xtr 15: C4E sensor reading

Last edition: Nov 13th, 2018 |

Basic example that turns on, reads and turn off the sensor. Measured parameters are stored in the corresponding class variables and printed by the serial monitor.

» Sw xtr 19: NTU sensor reading

Last edition: Nov 13th, 2018 |

Basic example that turns on, reads and turn off the sensor. Measured parameters are stored in the corresponding class variables and printed by the serial monitor.

» Sw xtr 23: CTZN sensor reading

Last edition: Nov 13th, 2018 |

Basic example that turns on, reads and turn off the sensor. Measured parameters are stored in the corresponding class variables and printed by the serial monitor.

» Sw xtr 27: MES5 sensor reading

Last edition: Nov 13th, 2018 |

Basic example that turns on, reads and turn off the sensor. Measured parameters are stored in the corresponding class variables and printed by the serial monitor.

» Sw xtr 32: BME280 sensor reading

Last edition: Nov 13th, 2018 |

Basic example that turns on, reads and turn off the sensor. Measured parameters are stored in the corresponding class variables and printed by the serial monitor.

» Sw xtr 33: TSL2561 sensor reading

Last edition: Nov 13th, 2018 |

Basic example that turns on, reads and turn off the sensor. Measured parameters are stored in the corresponding class variables and printed by the serial monitor.

» Sw xtr 34: MB7040 sensor reading

Last edition: Nov 13th, 2018 |

Basic example that turns on, reads and turn off the sensor. Measured parameters are stored in the corresponding class variables and printed by the serial monitor.