Development

Examples:

Communication / 802.15.4

» 802 01: Configure XBee

Last edition: Jan 10th, 2017 |

This program shows how to configure basic XBee parameters in order to communicate between different XBee devices using the same network.

» 802 06a: Send broadcast

Last edition: Jan 10th, 2017 |

This program shows how to send packets with XBee-802.15.4 modules. Broadcast address (0x000000000000FFFF) is specified as destination address.

» 802 08: Get RSSI

Last edition: Jan 10th, 2017 |

This program shows how to get RSSI value from the last received packet. In this protocol it is possible to extract this information from each packet. Besides, there is an API function which shows this information. Before running this example, make sure there is another emitter sending packets to this XBee module in order to receive information.

» 802 09a: Expansion board TX

Last edition: Jan 10th, 2017 |

This example shows how to use two XBee modules simultaneously in Waspmote using the Expansion board. Two different objects are created in this code, each one is used for each module. One is connected in the standard socket (SOCKET0) and the other one is connected to the Expansion board (SOCKET1)

» 802 10: Set low power mode

Last edition: Jan 10th, 2017 |

This program shows how to set different low power states in XBee-802.15.4 modules * Pin Hibernate (SM = 1): XBee is put to sleep and is wake up by setting a pin high and low * Pin Hibernate (SM = 2): The same as before, but more consumption and faster wake up

» 802 11a: Complete example TX

Last edition: Jan 10th, 2017 |

This is a complete example for XBee 802.15.4. This example shows how to send a packet using unicast 64-bit destination address. After sending the packet, Waspmote waits for the response of the receiver and prints all available information

» 802 11b: Complete example RX

Last edition: Jan 10th, 2017 |

This is a complete example for XBee 802.15.4. This example shows how to receive a packet. When the source address is the expected one, an answer is sent back to the sending Waspmote

» 802 13: Scan Network

Last edition: Jan 10th, 2017 |

This program shows how to scan the XBee's network in order to find other XBee modules. This example prints all available data within the API structures

» 802 14a: Node search TX

Last edition: Jan 10th, 2017 |

This program shows how to search for a specific node inside the XBee's network. Once the node has been found a packet is sent to this node.