Development

Examples:

Communication / 868LP

» 868LP 04a: Send broadcast

Last edition: Jan 10th, 2017 |

This program shows how to send packets with XBee-868LP modules. Broadcast address (0x000000000000FFFF) is specified as destination address

» 868LP 05: Get RSSI

Last edition: Jan 10th, 2017 |

This program shows how to get RSSI value from the last received packet. For this protocol, there is an API function which shows this information. Before running this example, make sure there is another emitter sending packets to this XBee module in order to receive information.

» 868LP 08a: Complete example TX

Last edition: Jan 10th, 2017 |

This is a complete example for XBee-868LPMhz. This example shows how to send a packet using unicast 64-bit destination address. After sending the packet, Waspmote waits for the response of the receiver and prints all available information

» 868LP 08b: Complete example RX

Last edition: Jan 10th, 2017 |

This is a complete example for XBee-868LP This example shows how to receive a packet. When the source address is the expected one, an answer is sent back to the emitter Waspmote

» 868LP 09: Scan network

Last edition: Jan 10th, 2017 |

This program shows how to scan the XBee's network in order to find other XBee modules. This example prints all available data within the API structures

» 868LP 10: Node search TX

Last edition: Jan 10th, 2017 |

This program shows how to search for a specific node inside the XBee's network. Once the node has been found a packet is sent to this node.

» 868LP 10b: Node search RX

Last edition: Jan 10th, 2017 |

This program shows how to search for a specific node inside the XBee's network. Once the node has been found a packet is sent to this node.

» 868LP 12: Power level

Last edition: Jan 10th, 2017 |

This program shows how to set and read the power mode at which the XBee module transmits at. Parameter Range: 0 - 4(default)