Development

Examples:

Communication / 900HP

» 900HP 04a: Send broadcast

Last edition: Jun 28th, 2017 |

This program shows how to send packets with XBee-900HP modules. Broadcast address (0x000000000000FFFF) is specified as destination address

» 900HP 05: Get RSSI

Last edition: Jan 10th, 2017 |

This program shows how to get RSSI value from the last received packet. For this protocol, there is an API function which shows this information. Before running this example, make sure there is another emitter sending packets to this XBee module in order to receive information

» 900HP 08a: Complete example TX

Last edition: Jan 10th, 2017 |

This example shows how to send a packet using unicast 64-bit destination address. After sending the packet, Waspmote waits for the response of the receiver and prints all available information

» 900HP 09: Scan network

Last edition: Jan 10th, 2017 |

This program shows how to scan the XBee's network in order to find other XBee modules. This example prints all available data within the API structures

» 900HP 10a: Node search TX

Last edition: Jan 10th, 2017 |

This program shows how to search for a specific node inside the XBee's network. Once the node has been found a packet is sent to this node

» 900HP 10b: Node search RX

Last edition: Jan 10th, 2017 |

This program shows how to search for a specific node inside the XBee's network. Once the node has been found a packet is sent to this node

» 900HP 12: Set power level

Last edition: Jan 10th, 2017 |

This program shows how to set the power level * of the XBee module. Possible values: * PL = 0 --> +7 dBm, (5 mW) * PL = 1 --> +15 dBm, (32 mW) * PL = 2 --> +18 dBm, (63 mW) * PL = 3 --> +21 dBm, (125 mW) * PL = 4 --> +24 dBm, (250 mW)