Development

Examples:

Communication / DigiMesh

» DM 01: Configure XBee

Last edition: Jan 10th, 2017 |

This program shows how to configure basic XBee parameters in order to communicate between different XBee devices using the same network.

» DM 02: Send packets

Last edition: Jan 10th, 2017 |

This program shows how to send packets to a gateway indicating the MAC address of the receiving XBee module

» DM 04a: Send broadcast

Last edition: Jan 10th, 2017 |

This program shows how to send packets with XBee-Digimesh modules. Broadcast address (0x000000000000FFFF) is specified as destination address

» DM 05: Get RSSI

Last edition: Jan 10th, 2017 |

This program shows how to get RSSI value from the last received packet. For this protocol, there is an API function which shows this information. Before running this example, make sure there is another emitter sending packets to this XBee module in order to receive information.

» DM 06a: Expansion board TX

Last edition: Jan 10th, 2017 |

This example shows how to use two XBee modules simultaneously in Waspmote using the Expansion board. Two different objects are created in this code, each one is used for each module. One is connected in the standard socket (SOCKET0) and the other one is connected to the Expansion board (SOCKET1)

» DM 08a: Complete example TX

Last edition: Jan 10th, 2017 |

This is a complete example for XBee-Digimesh. This example shows how to send a packet using unicast 64-bit destination address. After sending the packet, Waspmote waits for the response of the receiver and prints all available information

» DM 08b: Complete example RX

Last edition: Jan 10th, 2017 |

This is a complete example for XBee Digimesh. This example shows how to receive a packet. When the source address is the expected one, an answer is sent back to the emitter Waspmote

» DM 10: Scan network

Last edition: Jan 10th, 2017 |

This program shows how to scan the XBee's network in order to find other XBee modules. This example prints all available data within the API structures

» DM 11: Node search

Last edition: Jan 10th, 2017 |

This program shows how to search for a specific node inside the XBee's network. Once the node has been found a packet is sent to this node.

» DM 11a: Node search TX

Last edition: Jan 10th, 2017 |

This program shows how to search for a specific node inside the XBee's network. Once the node has been found a packet is sent to this node.

» DM 11b: Node search RX

Last edition: Jan 10th, 2017 |

Explanation: This program shows how to set the node identifier. Once the node has been configured is ready to receive.