Development

Examples:

Communication / LoRaWAN

» LoRaWAN 02a: Channels EU

Last edition: Feb 07th, 2017 |

This example shows how to configure the channels settings. There are 16 channels. The first three of them are always preconfigured and cannot be changed: 868.1 MHz, 868.3 MHz and 868.5 MHz. Besides other parameters can be changed in all channels: Duty Cycle, Data rate range and channel status

» LoRaWAN P2P 01: Configure

Last edition: Jan 10th, 2017 |

This example shows how to configure the module for P2P mode and the corresponding parameters. The user must keep in mind that every time the module is switched on, the radio settings MUST be set again.

» LoRaWAN P2P 02: Send

Last edition: Jan 10th, 2017 |

This example shows how to configure the module for P2P mode and the corresponding parameters. After this, the example shows how to send packets to other radio modules which must be set with the same radio settings

» LoRaWAN P2P 03: Receive

Last edition: Jan 10th, 2017 |

This example shows how to configure the module for P2P mode and the corresponding parameters. After this, the example shows how to receive packets from other radio modules which must be set with the same radio settings

» LoRaWAN P2P 04: Hybrid P2P / LoRaWAN

Last edition: Jan 10th, 2017 |

This example shows how to configure the module for P2P mode and LoRaWAN mode too. In this code, the Waspmote waits for new incoming P2P packets. Then routes the information received to the LoRaWAN gateway.