Quick question on attaching the RFID module

uilt · **Joined:** Wed Jun 06, 2012 7:03 pm **Posts:** 68

Hello everybody!

I have an RFID module that I can't figure out how to attach to its corresponding board. It seems as if there are 5 pins on the module, whereas only three ports exist on the board. Am I doing something wrong here? I've attached an image for reference.

Thanks for the help!

libelium-dev · **Joined:** Mon Sep 28, 2009 1:06 pm **Posts:** 7440

Hi uilt,

you should connect the three pins in the middle of the connector, living one male pin unconnected on each side of the receptacle.

Regards.

uilt · **Joined:** Wed Jun 06, 2012 7:03 pm **Posts:** 68

Thanks for your clarification on this issue!