Reading Values with Waspmote

rollinga · **Joined:** Fri Jun 15, 2012 1:16 pm **Posts:** 51

In page 18 of the Waspmote Technical Guide there are digital and analog inputs. Can I use them to read the value from a Horizontal Liquid Level Sensor? If I can, how I should connect it?

Thanks in advance

libelium-dev · **Joined:** Mon Sep 28, 2009 1:06 pm **Posts:** 7472

Hi rollinga,

the liquid level sensor is digital, so you can read it from any digital or analog pin, but take into account that you cannot connect it directly to Waspmote since you need a pull up or pull down resistor.

Regards.