Hi,
I've got one little question about the OTAP:

When doing a scan_nodes, it works fine since it shows me the waspmotes I have.
However, when I try a send, it shows a 'Finished' after sending data, but I don't have the "PROGRAM RECEIVED OK" messages from either of the 2 waspmotes I send the code to.

http://img21.imageshack.us/img21/4994/capturecfi.png

Does that mean that the sending kind of failed, even if showing a 'Finished' after taking some time?

I was wondering if the SD cards can be the real problem?
My question is : What can I do in the OTA without the SD cards?
If the SD cards aren't correct, there won't be any data sent?

Because I have an SD card but can't know how to configure it to make this sending data work.
(The only thing explained in the guide is reading the size of the SD)

PS : Actually, I think I have the same problem as the one in this thread:
viewtopic.php?f=19&t=8913

Hi,

1. Did you get your SD cards from Libelium?
2. Have you ever check if the program is inside the SD card? Try with get_boot_list
3. Does your Waspmote work correctly after not showing the message. Does it answer to scan_nodes?
4. Little trick: next time you try it indoors. Connect a USB port to your Waspmote and open a serial port to monitor the output of your Waspmote. Thus, you'll be able to see if the mote responds with the message OK or ERROR.

Best regards