Post a new topicPost a reply Page 1 of 1   [ 4 posts ]
Author Message
 Post subject: OTAP scan node
PostPosted: Thu May 03, 2012 3:33 am 

Joined: Tue Mar 13, 2012 6:04 am
Posts: 21
Hi Libelium,
I am not that sure about how OTAP work still. The sample code even in the waspmote, the code should be uploaded to the end device, am i right?
Do I need to upload any code to my coordinator?

I have tried scanning, the result I got was

Code:
Total Nodes: 0 - Time elapsed: 10s


May I know which part of it is wrong?
Tyvm.


Top
 Profile  
 
 Post subject: Re: OTAP scan node
PostPosted: Thu May 03, 2012 8:47 am 

Joined: Fri Jan 13, 2012 2:27 pm
Posts: 34
zoeyeo wrote:
Hi Libelium,
I am not that sure about how OTAP work still. The sample code even in the waspmote, the code should be uploaded to the end device, am i right?
Do I need to upload any code to my coordinator?

I have tried scanning, the result I got was

Code:
Total Nodes: 0 - Time elapsed: 10s


May I know which part of it is wrong?
Tyvm.



Using X-CTU, make sure your Gateway is configured to use API=1 and your waspmotes to use API=2. Also make sure that they use the same channel and have the same PAN ID. Then make sure these match up with what you have set in your xbee.conf file.


Top
 Profile  
 
 Post subject: Re: OTAP scan node
PostPosted: Thu May 03, 2012 9:34 am 

Joined: Tue Mar 13, 2012 6:04 am
Posts: 21
Hi Fab4,
I still encounter the same problem after I changed the API.

I have a question about the PAN ID. It says that, the PAN ID is 0xFFFF, so I need to use the first 4 digit or the last 4 digit for my PAN ID.

My channel is C, does it matter that i put C instead of 12?

I have a question about the SD card too. Do I need to insert the SD card? Insert into my end device or coordinator?

tyvm!


Top
 Profile  
 
 Post subject: Re: OTAP scan node
PostPosted: Tue May 08, 2012 1:30 pm 

Joined: Mon Sep 28, 2009 1:06 pm
Posts: 7516
Hi,

First of all you must make sure taht allt your XBee modules have the same configuration. In case you use XBee ZB modules, you must keep in mind that routers and end devices connect to the coordinator, so it is not that easy to connect all of them together. Are you sure about this first step?

Best regards


Top
 Profile  
 
Display posts from previous:  Sort by  
Post a new topicPost a reply Page 1 of 1   [ 4 posts ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
cron


Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
Libelium theme based on 610nm Style by Daniel St. Jules of http://www.gamexe.net


© Libelium Comunicaciones Distribuidas S.L. | Terms of use