How can I change parameters of Sensor Network?

jieyang · **Joined:** Wed Aug 31, 2011 11:56 am **Posts:** 41

hi,

Under 802.15.4 model of Sensor Network, I try to set "Network address" to "1111" as manual, but error "Network Address FAIL > 0" always be there, what is the problem?

Additionally, I also found I could not change network id, frequency and so on in that page because everything has been decided by xbee coordinator when the meshilium is starting. In that case, why the manager system provide such options for us?

I am totally new to meshilium, even waspmote, sorry for this boring questions and I appreciate of any help.

libelium-dev · **Joined:** Mon Sep 28, 2009 1:06 pm **Posts:** 7472

The inability to changing parameters of a zigbee coordinator and showing them as editable in the Manager System is a known bug of the actual Manager System. We are fixing it for next releases.

jieyang · **Joined:** Wed Aug 31, 2011 11:56 am **Posts:** 41

libelium-dev wrote:

The inability to changing parameters of a zigbee coordinator and showing them as editable in the Manager System is a known bug of the actual Manager System. We are fixing it for next releases.

So do you mean these parameters can be changed in the next release? or can not?

libelium-dev · **Joined:** Mon Sep 28, 2009 1:06 pm **Posts:** 7472

That parameters are automatically configured by the zigbee module, so in next releases they'll be only shown for information.

jieyang · **Joined:** Wed Aug 31, 2011 11:56 am **Posts:** 41

libelium-dev wrote:

That parameters are automatically configured by the zigbee module, so in next releases they'll be only shown for information.

Thank you very much:)