Hi,

I've several waspmotes. Two Waspmotes don't work properly. In one device, the GPS doesn't work and in the other waspmote, the alarms don't work (so, I can't use the deepSleep,etc...). I've using the examples codes. The devices are practically news and they are in good state.

I've tested all the other waspmotes and the examples work well. I'm begining to think that the devices are defective.

Are there any form to check that the device is well?

Thanks

Hi vellamy,

could you please follow the checklist provided in this post, so we can find out where is the problem in your boards?

Regards.

Good Morning!

GPS problem:
The waspmote never conects with the satelites. The follow function work well in this device:
GPS.ON();
GPS.setMode(GPS_ON); // set GPS on
GPS.begin();// open the uart
GPS.init();
GPS.getMode()
GPS.getLibVersion()

Futhermore, the Wasmote read correctly the file: "ephemeris.txt", however, It can't load the "ephemeris.txt".

The conections are ok, the other element also are ok, the program are ok and, the same conection and program works well other devices.(The proofs were outside)

What can I do to solve this?
I was thinking in having measures with the polimeter or use the guarantee.

Dear vellamy,

As you say, the fact that in the same conditions all the Waspmotes work well and one does not work can mean there is a hw problem. We will handle this through the Technical Service. Please fill the following form http://www.libelium.com/support/technicalservice and refer to this post in it.

Obviously, if the products are in warranty we will repare/replace them free of cost for you.

Best regards