Problems in Meshilium/comand AT

catolica · **Joined:** Tue Feb 07, 2012 7:40 pm **Posts:** 15

Sirs,

I posting the comands AT used in Meshilium and responses these comands:

meshlium:~# capturer S0 38400
setting speed 38400
ttyS0 chosen
...
Press Ctrl+c to close the program
+++ok
atch
error
atid
3332
atee
error
atvr
1022
athv
1c42
atai
error
atct
c8

I hope you can tell us what may be occurring.
Awaiting answer.

libelium-dev · **Joined:** Mon Sep 28, 2009 1:06 pm **Posts:** 7812

Hello Catolica,
Apparently, according to the responses at command channel is not configured, you can configure it from the Manager System in Sensor Network, and press the button Save, next press Check Status. Now the channel should be configured.

Please inform us the result and if the issue is resolved

Best Regards

catolica · **Joined:** Tue Feb 07, 2012 7:40 pm **Posts:** 15

Dear Libelium,

this button Save in the System Manager not working!!!! Please see topic viewtopic.php?f=4&t=8587.

Regards,
Católica

libelium-dev · **Joined:** Mon Sep 28, 2009 1:06 pm **Posts:** 7812

Hello catolica

Your Xbee is XSC too??

Best Regards

catolica · **Joined:** Tue Feb 07, 2012 7:40 pm **Posts:** 15

Hi Libelium-dev,

Yes our Xbee is XSC.

Regards,
Catolica

libelium-dev · **Joined:** Mon Sep 28, 2009 1:06 pm **Posts:** 7812

Hi catolica,

If the button save is not working, try to save with the ZigBee capturer stopped

Please, execute

Code:

/etc/init.d/ZigbeeScanD.sh stop

Then, press save and check in Manager System.

Best regards