Development v12

Warning - Product Update

All the resources present on this section belong to Waspmote v12, Waspmote Plug & Sense! v12 and Meshlium v3.8.

If you have a Waspmote v15, Waspmote Plug & Sense! v15 or Meshlium v4.0 please go to the new Development Section.

Check what is your version and what are the differences between the old and the new one in this document.

Examples:

Communication / 868

» 868 02: Send packets

Last edition: Jan 10th, 2017 | Categories: Communication, 868

This program shows how to send packets to a gateway indicating the MAC address of the receiving XBee module

» 868 04a: Send broadcast

Last edition: Jan 10th, 2017 | Categories: Communication, 868

This program shows how to send packets with XBee-868 modules. Broadcast address (0x000000000000FFFF) is specified as destination address

» 868 05: Get RSSI

Last edition: Jan 10th, 2017 | Categories: Communication, 868

This program shows how to get RSSI value from the last received packet. For this protocol, there is an API function which shows this information. Before running this example, make sure there is another emitter sending packets to this XBee module in order to receive information.

» 868 06a: Expansion board TX

Last edition: Jan 10th, 2017 | Categories: Communication, 868

This example shows how to use two XBee modules simultaneously in Waspmote using the Expansion board. Two different objects are created in this code, each one is used for each module. One is plugged to the standard socket (SOCKET0) and the other one is plugged to the Expansion radio board (SOCKET1)

» 868 07: Set low power mode

Last edition: Jan 10th, 2017 | Categories: Communication, 868

This program shows how to set different a low power states in XBee-868 modules * SM=0: Normal Mode * SM=1: Asynchronous Pin Sleep Mode

» 868 08a: Complete example TX

Last edition: Jan 10th, 2017 | Categories: Communication, 868

This is a complete example for XBee-868Mhz. This example shows how to send a packet using unicast 64-bit destination address. After sending the packet, Waspmote waits for the response of the receiver and prints all available information

» 868 08b: Complete example RX

Last edition: Jan 10th, 2017 | Categories: Communication, 868

This is a complete example for XBee 868. This example shows how to receive a packet. When the source address is the expected one, an answer is sent back to the sending Waspmote

» 868 09: Scan network

Last edition: Jan 10th, 2017 | Categories: Communication, 868

This program shows how to scan the XBee's network in order to find other XBee modules. This example prints all available data within the API structures

» 868 10a: Node search TX

Last edition: Jan 10th, 2017 | Categories: Communication, 868

This program shows how to search for a specific node inside the XBee's network. Once the node has been found a packet is sent to this node.

» 868 10b: Node search RX

Last edition: Jan 10th, 2017 | Categories: Communication, 868

This program shows how to search for a specific node inside the XBee's network. Once the node has been found a packet is sent to this node.

» 868 12: Set/Read Power Level

Last edition: Jan 10th, 2017 | Categories: Communication, 868

This program shows how to set and read the power mode at which the XBee module transmits at. Parameter Range: 0 - 4(default)