Development v12

Warning - Product Update

All the resources present on this section belong to Waspmote v12, Waspmote Plug & Sense! v12 and Meshlium v3.8.

If you have a Waspmote v15, Waspmote Plug & Sense! v15 or Meshlium v4.0 please go to the new Development Section.

Check what is your version and what are the differences between the old and the new one in this document.

Examples:

Communication / CAN Bus

» CAN Bus 01: Basic Example

Last edition: Jan 10th, 2017 | Categories: Communication, CAN Bus

This sketch shows how to send data through CAN Bus standard. CAN Bus (for controller area network) is a vehicle bus standard designed to allow micro controllers and devices to communicate with each other within a vehicle without a host compute.

» CAN Bus 02: Get Engine RPM

Last edition: Jan 10th, 2017 | Categories: Communication, CAN Bus

This skecth shows how to get the engine RPM using the standard OBD-II PIDs codes. This codes are used to request data from a vehicle, used as a diagnostic tool.

» CAN Bus 03: Get Vehicle Speed

Last edition: Jan 10th, 2017 | Categories: Communication, CAN Bus

This sketch shows how to get the Vehicle Speed using the standard OBD-II PIDs codes. This codes are used to request data from a vehicle, used as a diagnostic tool.

» CAN Bus 04: Dash Board

Last edition: Jan 10th, 2017 | Categories: Communication, CAN Bus

This sketch shows how to get the most important parameters from a vehicle using the standard OBD-II PIDs codes. This codes are used to request data from a vehicle, used as a diagnostic tool.

» CAN Bus 05: General PIDs

Last edition: Jan 10th, 2017 | Categories: Communication, CAN Bus

This sketch shows how to use the general function CiARequest and the standard OBD-II PIDs codes to get data from the vehicle. This codes are used to request data from a vehicle, used as a diagnostic tool.