Development v12

Warning - Product Update

All the resources present on this section belong to Waspmote v12, Waspmote Plug & Sense! v12 and Meshlium v3.8.

If you have a Waspmote v15, Waspmote Plug & Sense! v15 or Meshlium v4.0 please go to the new Development Section.

Check what is your version and what are the differences between the old and the new one in this document.

Examples:

Communication / LoRaWAN

» LoRaWAN 01b: Configure module US or AU

Last edition: Apr 12th, 2018 | Categories: Communication, LoRaWAN

This example shows how to configure the module and all general settings related to back-end registration process for LoRaWAN US and LoRaWAN AU modules

» LoRaWAN 02a: Channels EU or IN or ASIA-PAC / LATAM

Last edition: Oct 30th, 2018 | Categories: Communication, LoRaWAN

This example shows how to configure the channels settings. There are 16 channels. The first three of them are always preconfigured and cannot be changed: 868.1 MHz, 868.3 MHz and 868.5 MHz. Besides other parameters can be changed in all channels: Duty Cycle, Data rate range and channel status

» LoRaWAN 08: Join ABP send frame

Last edition: Oct 30th, 2018 | Categories: Communication, LoRaWAN

This example shows how to configure the module and send frames to a LoRaWAN gateway with ACK after join a network using ABP

» LoRaWAN 11: Join OTAA send frame

Last edition: Oct 30th, 2018 | Categories: Communication, LoRaWAN

This example shows how to configure the module and send frames to a LoRaWAN gateway with ACK after join a network using OTAA

» LoRaWAN P2P 01: Configure

Last edition: May 18th, 2018 | Categories: Communication, LoRaWAN

This example shows how to configure the module for P2P mode and the corresponding parameters. The user must keep in mind that every time the module is switched on, the radio settings MUST be set again.

» LoRaWAN P2P 02: Send

Last edition: Oct 30th, 2018 | Categories: Communication, LoRaWAN

This example shows how to configure the module for P2P mode and the corresponding parameters. After this, the example shows how to send packets to other radio modules which must be set with the same radio settings

» LoRaWAN P2P 03: Receive

Last edition: Oct 30th, 2018 | Categories: Communication, LoRaWAN

This example shows how to configure the module for P2P mode and the corresponding parameters. After this, the example shows how to receive packets from other radio modules which must be set with the same radio settings

» LoRaWAN P2P 04: Hybrid P2P / LoRaWAN

Last edition: May 18th, 2018 | Categories: Communication, LoRaWAN

This example shows how to configure the module for P2P mode and LoRaWAN mode too. In this code, the Waspmote waits for new incoming P2P packets. Then routes the information received to the LoRaWAN gateway.