Development v12

Warning - Product Update

All the resources present on this section belong to Waspmote v12, Waspmote Plug & Sense! v12 and Meshlium v3.8.

If you have a Waspmote v15, Waspmote Plug & Sense! v15 or Meshlium v4.0 please go to the new Development Section.

Check what is your version and what are the differences between the old and the new one in this document.

Examples:

General / Interrupts

» Int 05a: Sensor Event interrupt

Last edition: Jan 10th, 2017 | Categories: General, Interrupts

This example shows how to setup a threshold to the Sensor Event Board and enter sleep mode until an interruption occurs. Then show the value returned by the sensor board and print it.

» Int 05c: Smart Cities interrupt

Last edition: Jan 10th, 2017 | Categories: General, Interrupts

This example shows how to setup a threshold to the Smart Cities Board and enter sleep mode until an LDR sensor interruption occurs. Then show the value returned by the sensor board and print it.

» Int 07: All interrupts with deep sleep

Last edition: Jan 10th, 2017 | Categories: General, Interrupts

This example shows how set up all interruptions in the same code. Waspmote goes to deep sleep expecting some interruption source: - RTC - ACC - Pluviometer sensor - XBee Digimesh module