Development v12

Warning - Product Update

All the resources present on this section belong to Waspmote v12, Waspmote Plug & Sense! v12 and Meshlium v3.8.

If you have a Waspmote v15, Waspmote Plug & Sense! v15 or Meshlium v4.0 please go to the new Development Section.

Check what is your version and what are the differences between the old and the new one in this document.

» BLE 21 Software reset

This example shows how to make a software reset of the BLE module.

Required Materials

1 x Waspmote
1 x Battery
1 x Bluetooth Low Energy module
1 x Bluetooth module antenna
1 x Expansion board (if socket 1 is used)
1 x SD card

Notes

- Socket 0 is used by default
- EEPROM is used in this example by default.
- Never unplug module while Waspmote is turned ON.
- Bluetooth module antenna should be connected.
- The battery must be connected in ANY example.
- This example can be executed in Waspmote v12 and Waspmote v15

Code

/*
 *  ------------------ [BLE_21] - Software reset ------------------- 
 *
 *  Explanation: This example shows how to make a software reset 
 *  of the BLE module
 *
 *  Copyright (C) 2016 Libelium Comunicaciones Distribuidas S.L.
 *  http://www.libelium.com
 *
 *  This program is free software: you can redistribute it and/or modify
 *  it under the terms of the GNU General Public License as published by
 *  the Free Software Foundation, either version 3 of the License, or
 *  (at your option) any later version.
 * 
 *  This program is distributed in the hope that it will be useful,
 *  but WITHOUT ANY WARRANTY; without even the implied warranty of
 *  MERCHANTABILITY or FITNESS ARTICULAR PURPOSE.  See the
 *  GNU General Public License for more details.
 * 
 *  You should have received a copy of the GNU General Public License
 *  along with this program.  If not, see <http://www.gnu.org/licenses/>.
 *
 *  Version:		1.0
 *  Design:		David Gascón
 *  Implementation:	Javier Siscart
 */

#include <WaspBLE.h>

// Auxiliary variable
uint8_t aux = 0;

void setup() 
{  
  USB.println("BLE_21 Example");  

  // 0. Turn BLE module ON
  BLE.ON(SOCKET0);
}

void loop() 
{

  // Send the reset command to the module.
  aux = BLE.reset();
  if(aux == 1 )
  {
    // reset event found.
    USB.println("Module has been reset");  
  }
  else 
  {
    USB.println("Reset failed");  
  }

  delay(5000);

}

Output

H#
BLE_21 Example
Module has been reset

Quick Publish: