Development v12

Warning - Product Update

All the resources present on this section belong to Waspmote v12, Waspmote Plug & Sense! v12 and Meshlium v3.8.

If you have a Waspmote v15, Waspmote Plug & Sense! v15 or Meshlium v4.0 please go to the new Development Section.

Check what is your version and what are the differences between the old and the new one in this document.

» SW 06: Temperature Sensor

Turn on the Smart Water Board and reads the Temperature sensor printing the result through the USB

Required Materials

1 x Waspmote
1 x Battery
1 x Smart Water Sensor Board
1 x PT1000 temperature Sensor


PT1000 sensor is generally used with the pH sensor for temperature compensation
It is advisable to space at least ten seconds the measurements of the PT1000 sensor in order to prevent the sensor from heating by Joule effect.


 *  ------ [SW_06] - Temperature sensor Reading for Smart Water-------- 
 *  Explanation: Turn on the Smart Water Board and reads the Temperature
 *  sensor printing the result through the USB
 *  Copyright (C) 2016 Libelium Comunicaciones Distribuidas S.L. 
 *  This program is free software: you can redistribute it and/or modify 
 *  it under the terms of the GNU General Public License as published by 
 *  the Free Software Foundation, either version 3 of the License, or 
 *  (at your option) any later version. 
 *  This program is distributed in the hope that it will be useful, 
 *  but WITHOUT ANY WARRANTY; without even the implied warranty of 
 *  GNU General Public License for more details. 
 *  You should have received a copy of the GNU General Public License 
 *  along with this program.  If not, see <>. 
 *  Version:           3.0
 *  Design:            David Gascón 
 *  Implementation:    Ahmad Saad

#include <WaspSensorSW.h>

// This variable will store the temperature value
float temp;

// Create an instance of the class
pt1000Class TemperatureSensor;

char node_ID[] = "Temperature_example";

void setup()
  USB.println(F("Water temperature PT-1000 example for Smart Water..."));
  // 1. Turn ON the Smart Water sensor board 

void loop()
  // 2. read the sensors
  // Reading of the Temperature sensor
  temp = TemperatureSensor.readTemperature();

  // 3. Print the output values

  // Print of the results
  USB.print(F("Temperature (celsius degrees): "));

  // Delay


Temperature (celsius degrees): 20.9230957031
Temperature (celsius degrees): 20.8330688476
Temperature (celsius degrees): 20.9158630371
Temperature (celsius degrees): 20.9450683593
Temperature (celsius degrees): 20.9647216796
Temperature (celsius degrees): 20.9499206542

Quick Publish: