Search found 25 matches

by jburgues
Mon Sep 09, 2019 9:39 am
Forum: General Questions
Topic: Battery connector
Replies: 1
Views: 1647

Re: Battery connector

No need for your reply anymore. I wasted several hours of my time looking for the connector provided your "company policy" does not allow to reveal component names. In case somebody else needs it, here are the component names: The 3-pin female battery connector is not a JST connector. It is a Hirose...
by jburgues
Fri Sep 06, 2019 11:24 am
Forum: General Questions
Topic: Battery connector
Replies: 1
Views: 1647

Battery connector

Hello,

I have broken the battery connector (3-pin female, https://ibb.co/vL7z1WT) that goes into the 3-pin male socket on the waspmote, while trying to disconnect the battery from the waspmote.

What is the name of this connector so I can buy a new one and fix it?

Thanks,
Javier.
by jburgues
Wed Jul 31, 2019 1:12 pm
Forum: Programming - API
Topic: Communication waspMote and Arduino
Replies: 1
Views: 2407

Communication waspMote and Arduino

Good morning, I'm trying to connect an Arduino Mega 2560 and a WaspMote PRO v1.5 so that the values from 16 sensors installed on the Arduino shield are transmitted to the waspMote upon request from the waspMote. Thus, Arduino acts as a slave and Waspmote as a master. I have initially tried it using ...
by jburgues
Thu Jul 25, 2019 11:02 am
Forum: Sensor Boards
Topic: Technical question [board Gases PRO]
Replies: 3
Views: 3397

Re: Technical question [board Gases PRO]

Hello, I have sent pictures via email to one of your colleagues (Ana Sancho) since I was unable to upload them to the forum. Please contact her. If I understood it correctly, the white marks are two solid rectangles that originate from the footprint of the 3x2 male socket on the AFE board https://cd...
by jburgues
Tue Jul 23, 2019 11:13 am
Forum: Sensor Boards
Topic: Technical question [board Gases PRO]
Replies: 3
Views: 3397

Technical question [board Gases PRO]

Good morning, I have two technical questions regarding the instalation of the board gases PRO to the waspMote and the instalation of the gas sensors onto the gases PRO board. First, my gases PRO board has a 11x2 male socket (sensor I/O) whereas the waspMote has a 12x2 female socket.. Is there a miss...