I am looking at the example from gp_19_aqm since it seems to be what I need to read the Gas Sensors on a Waspmote PRO with v12 sensors. In that code, temp, humidity and pressure are read but as follows:libelium-dev wrote:Hi Mark,
The code above is to read ONLY the BME sensor, on the examples codes of the gases sensors the code part to read the BME sensor is already included.
temperature = CO.getTemp();
humidity = CO.getHumidity();
pressure = CO.getPressure();
Is this what you mean when you say that the "code part to read the BME sensor is already included"? Or do I need to add the code such as was shown earlier in this thread that explicitly reads the BME sensor?
Thanks for your help. Sorry if I am making this more complicated than it needs to be.