Question about connecting non-standard sensor

Post Reply
telesto_sd
Posts: 21
Joined: Mon Oct 07, 2013 11:19 am

Question about connecting non-standard sensor

Post by telesto_sd » Tue Mar 26, 2019 10:09 am

Hi,

We are going to purchase probably a Smart Cities PRO Plug & Sense with a few of the standard sensors but we need to connect an extra (not standard for the specific) sensor, actually a simple magnetic switch, thus I need a digital input plus Vdd and GND and a resistor. Since some of the sockets will not be used I could probably use one of them. Do you provide any schematics for the sockets or if we could use a Hall Effect sensor that you provide for the Smart Security model?

GM

libelium-dev
Posts: 27967
Joined: Mon Sep 28, 2009 1:06 pm

Re: Question about connecting non-standard sensor

Post by libelium-dev » Wed Mar 27, 2019 10:16 am

Hi,

We are sorry but we can't provide the pin out of the sockets neither schematic. If you want a custom project, we could develop it. Please contact the sales department for more information.
http://www.libelium.com/contact/

Regards

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest