Page 1 of 1

OTA with Meshlium

Posted: Thu Oct 13, 2016 6:46 pm
by gmm
Hello,
I am trying to set up my Waspmote network to work with OTA, but I am a little confused on how to proceed.

I have some waspmotes and a Meshlium. In the "Over the air programming guide" it said that OTA operations are only available from de Gateway and not from Meshlium in case of using Zigbee, but later the guide shows how to send programs from Meshlium using OTA.

So I would like to know if it is necessary to have the Gateway or, on the contrary, simply having Meshlium is enough.

Thanks for the help.

Re: OTA with Meshlium

Posted: Fri Oct 14, 2016 11:00 am
by libelium-dev
Hi,

You can use OTA with Zigbee with Meshlium or with a gateway as it is explained at the OTA guide at point 5.5.
http://www.libelium.com/downloads/docum ... amming.pdf

You have all the information how to use the OTA Shell at point 5.4.

Remember you should change the Baudrate of the Xbee at the Meshlium as it's explained at this post,
viewtopic.php?f=30&t=22359&p=65275&hili ... ver#p65275

Regards