Set sensor value alarm

How to configure Meshlium or use the Manager System
Post Reply
mikismart
Posts: 25
Joined: Thu Jul 11, 2019 8:33 am
Company: Samek Engineering

Set sensor value alarm

Post by mikismart » Thu Aug 08, 2019 11:26 am

As I explain in the above I need to develop the programming of smart environment PRO device when it is deep-sleep mode the reading value of the sensor is High the system is back out to deep sleep and back to normal operation send the data to the 4G module. :roll: :roll: :roll:

libelium-dev
Posts: 27967
Joined: Mon Sep 28, 2009 1:06 pm

Re: Set sensor value alarm

Post by libelium-dev » Thu Aug 08, 2019 2:38 pm

Hi,

When the Waspmote is in deepSleep mode you can't read from the sensor. You should weak up the board with a fixed frequency to check the sensor and if it's higher than a value you can send a warning message.

You have a lot of examples in our development section and you should combine them to build your code, if you have any doubt in the process we will support you.
http://www.libelium.com/development/

Regards

Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests