Set sensor value alarm

How to configure Meshlium or use the Manager System
Post Reply
Posts: 25
Joined: Thu Jul 11, 2019 8:33 am
Company: Samek Engineering

Set sensor value alarm

Post by mikismart » Thu Aug 08, 2019 11:26 am

As I explain in the above I need to develop the programming of smart environment PRO device when it is deep-sleep mode the reading value of the sensor is High the system is back out to deep sleep and back to normal operation send the data to the 4G module. :roll: :roll: :roll:

Posts: 27967
Joined: Mon Sep 28, 2009 1:06 pm

Re: Set sensor value alarm

Post by libelium-dev » Thu Aug 08, 2019 2:38 pm


When the Waspmote is in deepSleep mode you can't read from the sensor. You should weak up the board with a fixed frequency to check the sensor and if it's higher than a value you can send a warning message.

You have a lot of examples in our development section and you should combine them to build your code, if you have any doubt in the process we will support you.


Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest