GMX 200 weather station

Everything about programming the platform and using the Waspmote API
Post Reply
Antonios
Posts: 10
Joined: Tue Feb 09, 2016 5:53 pm

GMX 200 weather station

Post by Antonios » Thu May 30, 2019 4:23 pm

Hello Guys,

I have followed the example provided at
http://www.libelium.com/development/plu ... r-reading/

for my gmx 200 weather station. However i observe that the outputs as not the same as in the example as for the timestamp i am getting the readings for the voltage (+11.8), the timestamp - (just the year 2019) appears in z orient and so on.

Could you please advise as to how to get the appropriate data for the z orient, time stamp and voltage please?

Thank you in advance
Antonio

libelium-dev
Posts: 27967
Joined: Mon Sep 28, 2009 1:06 pm

Re: GMX 200 weather station

Post by libelium-dev » Fri May 31, 2019 9:13 am

Hi Antonio,

It seems that the data receive from the weather station isn't parser properly.

What API version did you use to upload the code? Could you please try using the last API available, v041?
http://www.libelium.com/development/was ... lications/

In addition, please enable debug mode for agriculture xtreme nodes inside WaspSensorXtr.h file, upload the example code to the node again and share the output through the serial monitor with us to debug the issue in more deep.

Code: Select all

#define DEBUG_XTR	2
Regards

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest