Park sensor installation

jluengo83
Posts: 30
Joined: Tue Sep 18, 2018 10:04 pm
Company: Conure Telecom

Re: Park sensor installation

Post by jluengo83 » Tue Oct 02, 2018 10:34 pm

Thanks!

I have another question regarding to the battery shown as following:

how much are the thresholds for low, medium and normal battery voltage?


Looking forward for your answer.

libelium-dev
Posts: 27967
Joined: Mon Sep 28, 2009 1:06 pm

Re: Park sensor installation

Post by libelium-dev » Wed Oct 03, 2018 11:43 am

Hi,

Non-rechargeable batteries have a very plain discharge graph, so it isn't possible to know the remaining energy inside it. The battery status is set to 1 when the battery level is very low. It isn't possible detect intermediate states.

Regards

jluengo83
Posts: 30
Joined: Tue Sep 18, 2018 10:04 pm
Company: Conure Telecom

Re: Park sensor installation

Post by jluengo83 » Wed Oct 03, 2018 10:18 pm

Hi,

Could you please clarify this part of the sentence:

"The battery status is set to 1 when the battery level is very low".


Thanks.

MrM
Posts: 39
Joined: Wed Oct 12, 2016 2:28 pm

Re: Park sensor installation

Post by MrM » Wed Oct 03, 2018 11:55 pm

Hi,
jluengo83 wrote:
Wed Oct 03, 2018 10:18 pm
"The battery status is set to 1 when the battery level is very
You may need to take a look on frame structure especially the bit 6 of basic data byte. (From documentation)
Hope it'll be helpful.
Cheers.

libelium-dev
Posts: 27967
Joined: Mon Sep 28, 2009 1:06 pm

Re: Park sensor installation

Post by libelium-dev » Fri Oct 05, 2018 8:42 am

Hi,

As @MrM said, the batery status is sent in each frame. You can find more information here
http://www.libelium.com/downloads/docum ... df#page=16

Regards

jluengo83
Posts: 30
Joined: Tue Sep 18, 2018 10:04 pm
Company: Conure Telecom

Re: Park sensor installation

Post by jluengo83 » Tue Feb 19, 2019 8:26 pm

Hi,

On the page 15, in the basic frame bit 6 Battery status, it is mentioned that "‘1’ indicates that the battery has little charge and it will be necessary to change it". what is the indication of low voltage? Can you please let us know the threshold that when sensors report that percentage then it is needed to replace the battery on the sensor right away

Thank you.

libelium-dev
Posts: 27967
Joined: Mon Sep 28, 2009 1:06 pm

Re: Park sensor installation

Post by libelium-dev » Wed Feb 20, 2019 10:38 am

Hi,

There is a mistake in the guide, the battery isn't rechargeable, so the correct sentence is "‘1’ indicates that the battery has little charge and it will be necessary to replace it."

The non-rechargeable batteries have a very plain discharge graph, so it is not possible to know the remaining energy inside it. When the node indicates that the battery has little charge, it is recommended to replace the battery in the next few days.

Regards

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest