smart device app

Post Reply
loayalawi
Posts: 4
Joined: Tue Mar 26, 2019 1:44 pm
Company: APC

smart device app

Post by loayalawi » Fri Mar 29, 2019 5:22 pm

When configuring the smart parking sensors using the smart device app, under "lorawan parameters" the device eui, port, application key and the application eui, do we make these up? or do we enter the gateway credentials?

if we enter the gateway credentials, where do we configure the sensor "device eui" and "application key" and "application eui"?

as the gateway requires these information in order to connect to the sensor

libelium-dev
Posts: 27967
Joined: Mon Sep 28, 2009 1:06 pm

Re: smart device app

Post by libelium-dev » Mon Apr 01, 2019 9:39 am

Hi,

You have to set the LoRaWAN parameters according to the base station or back-end. You have to set the same key in both ways. You can use the LoRaWAN EUI to configure the device EUI field, so it will be an unique ID.

Regards

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest